Brother HL-2060 Service Manual page 109

Error Message
31 PRINT OVERRUN
32 BUFFER ERROR
34 MEMORY FULL
40 LINE ERROR
41 PRINT CHECK
Table 6.3 Error Messages
Meaning
Print overrun
Input buffer overflow
Work memory overflow
Error in the
communications circuit
Error in communication with
the engine controller
VI-27
Action
Press the CONTINUE switch
to start printing the next page.
Data which overran the print
area on the page cannot be
printed. Check your page
protection setting with the
MODE switch. Setting page
protection to the correct size
could solve this problem. If
printing at 600 dpi, you may
need to add optional SIMM
memory.
Press the CONTINUE switch
to resume printing.
Data lost in overflow cannot be
printed.
Press the CONTINUE switch
to resume printing. If the same
error should occur after you
press the CONTINUE switch,
turn off the printer. Wait a few
seconds, then turn it on again .
Reduce the input buffer size.
Turn off "KEEP PCL." Add
SIMM memory with power off.
Download font and the font
saved in the HDD card might
cause the error, for it occupies
the same work area as the
RAM. Memory expansion is
recommended in that case.
When the serial interface is
used, check the
communications parameters
such as baud rate, code type,
parity, and handshake
protocols. When the parallel
interface is used, check the
interface cable connection.
Turn off the printer. Wait a few
seconds, then turn it on again.
See M-17.