5
Typical Configuration
Before You Begin
You Should Have Done
C
ONFIGURING THE
M
ODEM
This chapter describes how to configure the ISDN LAN Modem for the typical
configuration. The typical configuration covers the basic setup and includes what
most users need to get up and running. It provides instructions for setting up your
ISDN line and connecting to the Internet. If you followed the instructions in the
Getting Started Guide, you have already set up the typical configuration. To see if
there are any additional changes you would like to make, you may want to look
over Chapter 6, "Advanced Configuration."
The configuration windows shown in this chapter may differ slightly from what is
displayed on your computer.
The typical configuration covers the following main steps.
Figure 34 Main Steps for Typical Configuration
Make sure that you have done the following.
Before you configure the ISDN LAN Modem, you should have already done the
following:
This
Installed the hardware as described in Chapter 3, "Hardware Description and
Installation."
Installed and set up TCP/IP on all computers you intend to connect to the ISDN
LAN Modem. If TCP/IP is not installed and set up, refer to Chapter 4.
ISDN LAN
Launch
Web Browser
Run
SPID Wizard
Run
ISP Wizard
Verify
Configuration
Need help?
Do you have a question about the 3C892 - OfficeConnect ISDN Lan Modem Router and is the answer not in the manual?
Questions and answers