To Install Water Filter; To Replace Water Filter - Electrolux 297122800 (0608) Use & Care Manual

TO INSTALL WATER FILTER:

• The water filter cartridge comes separate inside the unit.
Before installing the water filter, be sure to remove the filter
from the packaging and two plastic caps that protect the inlet
and outlet ports of the water filter. The water supply does not
need to be turned off.
• Insert the water filter cartridge into the filter housing. When
the cartridge is almost in, you will feel it stop against the clip
assembly in the back of the housing. The clip assembly holds
the filter cartridge firmly in place.
• At this point, you will need to push firmly until the cartridge
snaps fully in place. When completely in place, the front of the
filter cartridge will be flush with the front of the housing."

TO REPLACE WATER FILTER:

• It is not necessary to turn the water supply off to change the filter. Push the
filter release button, located to the right of the filter cartridge, to release the
filter from the housing. To minimize the possibility of the filter falling out of the
housing during removal, it would be best to hold the filter as it moves out
toward you. NOTE: A small amount of water may be released during this
operation. You should have a paper towel or dish cloth handy to wipe out any
water that may drip out of the filter or housing. Two small holes near the back
of the housing have been added for any excess water to escape. It would be
best to clear away any food near this area on the top shelf in advance of
removing the filter.
• Pull the old filter cartridge straight out of the housing and discard it.
• Then follow the instructions above for installing a water filter.
Refrigerator Features
15