Black Widow BW 4150 Installation Manual page 3

Starter Defeat Connectors
Using a volt/ohm meter locate the starter wire
(normally a heavier gauge wire) at the ignition
switch. This wire will show +12V only during
cranking. When this wire is cut the vehicle will
be unable to start.
Cut the BROWN starter disable wire (with the
two female connectors), and connect one side to
the vehicle's starter wire coming from the key
switch. Connect the other BROWN wire to the
wire going to the starter.
Plug the female connectors on the BROWN
wires to the .250 male spade lugs on the module.
With the BROWN wires connected to the
module, the vehicle should be able to start.
Plug in Connectors
4-Pin White Connector: Plug-in connector
port for dual stage shock sensor.
2-Pin Blue Connector: Plug-in connector port
for valet switch. Mount valet switch in an area
that is easily accessible from the driver's position.
2-Pin Red Connector: Plug-in connector port
for LED. Mount LED in an area where it may be
easily seen from either side of the vehicle.
3-Pin White Door Lock Connector: Plug-in
connector port for door lock harness or
optional door lock relay module (PDLM-3).
• BLUE WIRE - negative unlock output (-)
500mA and positive lock output (+) 250mA.
• RED WIRE - constant +12V low current
output (+) for relay modules, or inverters.
300mA relay trigger only. Do NOT use as a
power source for door lock relays.
• GREEN WIRE - negative lock output (-)
500mA and positive unlock output (-) 250mA.
3-Pin White Network Connector: The plug-in
network connector port is located on the side
of the main module. This network port may be
used with the optional personal computer
interface for diagnostics, software customization
and expanded programming options.
network also offers connection to several
optional accessories.
Adding Transmitters
To add a new transmitter to the system have the
desired transmitters ready and follow the Code
Learning sequence.
To enter Code Learning Mode:
1. Turn the ignition on, off, on, off and leave on.
• The siren will chirp 3 times.
2. Press and hold the Valet switch for 5
seconds.
• The siren will chirp 5 times.
3. Press the Lock Button on the transmitter.
• The siren will chirp once.
4. Press Lock Button on the transmitter again.
• The siren will chirp twice.
5. Repeat steps 3 and 4 for each additional
transmitter.
6. Turn off the ignition.
• The siren will chirp 3 times.
Two Car Operation
With the supplied 5-button transmitter it is
possible to control a second vehicle using the
same primary transmitter. For Car 2 enter the
Code Learning Mode as described above then
substitute the steps below for 3 and 4..
3. Press Button 5 twice followed by the Lock
Button.
• The siren will chirp once.
4. Press Button 5 twice followed by the Lock
Button.
• The siren will chirp twice.
3
The