Black Widow BW 4150 Installation Manual page 11

Problem
Range is poor.
Vehicle starts when armed.
Car will not start when
system is disarmed.
Keyless entry does
operate with remote.
Ignition triggered door lock
feature does not operate.
Car horn honks when system
disarmed and door is opened.
Car will not start and alarm
does not function properly.
LED INDICATIONS
On Solid = Valet Mode
Slow Flash = System Armed
Rapid Flash = Passive Arming
2 Flashes = Shock Sensor
4 Flashes = Door Trigger
5 Flashes = Hood/Trunk
TROUBLESHOOTING CONTINUED
Probable Cause
Antenna wire is grounded;
Module
interference from vehicle's
electrical system.
Wrong starter wire was cut.
Ignition wire does not have
+12V while cranking.
Bad connection on brown
starter
Defective starter defeat relay
not Wrong door lock polarity;
Wrong lock wires connected.
Yellow wire does not show
+12V; Door is open; Door
trigger input wrong polarity.
Vehicle's
system needs to be disarmed.
Vehicle battery dead or drops
below 9 volts when trying to
start the vehicle.
LED TAMPER ALERT
1 Flash = Optional Sensor
2 Flashes = Shock Sensor
4 Flashes = Door Trigger
5 Flashes = Hood/Trunk
is picking
wire harness;
factory security
INDICATIONS
11
Suggested Correction
Make sure antenna is not
up grounded; Relocate module or
route antenna away from
computer modules.
Connect to proper starter
wire. Connect YELLOW wire
to proper ignition wire
Repair connection at starter
wire; Replace module.
See door lock diagram; Verify
vehicle lock/unlock wires.
Connect YELLOW wire to
ignition wire; Close door;
Change door trigger polarity.
Locate disarm wire (usually
located in drivers kick panel)
and use unlock pulse to disarm
factory system.
Charge or replace battery.
PARKING LIGHTS
FUNCTIONS
Flash 1x = Doors Locked
Flash 2x = Doors Unlocked
Flash 3x = Open Zone
Indication (after arming)
Flash 3x after Disarm =
Tamper Alert