Table of Contents
Advertisement
Available languages
Available languages
Authentication—Select
Homepage—Depending on the access point you are setting
up, enter the web address or the address of the multimedia
messaging center.
Select
Options
>
following settings:
Network
type—Select
The other settings depend on the selected network type.
Phone IP address
your device.
DNS
address—In
of the primary DNS server. In
the IP address of the secondary DNS server. Contact your
internet service provider to obtain these addresses.
Proxy serv.
address—Define the address for the proxy server.
Proxy port
number—Enter the proxy port number.
Wireless LAN
Follow the instructions from your service provider.
WLAN netw.
name—Select
netw.. If you select an existing network,
and
WLAN security mode
of its access point device.
WLAN netw.
mode—Select
network and to allow devices to send and receive data
directly; a wireless LAN access point device is not needed.
102
Normal
or Secure.
Advanced settings
to change the
IPv4 settings
or
IPv6
(for IPv4 only)—Enter the IP address of
Primary name
serv.:, enter the IP address
Second. name
Enter manually
WLAN netw. mode
are determined by the settings
Ad-hoc
to create an ad hoc
WLAN security
802.1x
(not for ad hoc networks), or WPA/WPA2. If you
select
Open
and WPA functions can be used only if the network
supports them.
WLAN security
security mode:
settings.
Security settings for
Wep key in
up to four WEP keys. The same settings must be entered on
the wireless LAN access point device.
Authentication
server:, enter
authentication type between your device and the wireless
LAN access point device.
WEP key
key),
WEP key format (ASCII
key
(the WEP key data in the selected format).
Security settings for
WPA
mode—Select the means of authentication:
or
Search for
use an extensible authentication protocol (EAP) plug-in or
Pre-shared key
appropriate settings:
EAP plug-in settings
your service provider instructs.
mode—Select the encryption used: WEP,
network, no encryption is used. The WEP, 802.1x,
sett.—Enter the settings for the selected
WEP
are as follows:
use—Select the WEP key number. You can create
type—Select
Open
or
settings—Enter
WEP encryption
or Hexadecimal), and
802.1x
and
WPA/WPA2
to use a password. Complete the
(only for EAP)—Enter the settings as
Shared
for the
(length of the
WEP
are as follows:
EAP
to
Advertisement
Chapters
Table of Contents
