Table of Contents
Advertisement
Before using the machine for the first
time ensure that it is correctly
installed and connected. See
"Installation and connection". Also
check that the drain filter is securely
tightened to prevent the risk of water
leaks during use.
The washing machine has a sensor
which measures the amount of laundry
in the drum. This determines the
amount of detergent required. To allow
the load size indicator to function
correctly, you must first run a wash
programme without any laundry and
without detergent.
^ Open the stopcock.
^ Press the I-On/0-Off button in.
If the washing machine is being
switched on for the first time, the
welcome screen will appear.
The welcome screen will not appear
again once you have set the machine
up for first use as described in this
section, or once a programme lasting
longer than 1 hour has been
completed.
Before using for the first time
Reminder to remove transport struts
To avoid the risk of damage, the
transport struts must be removed
before the washing machine is used
for the first time. See "Installation
and connection" for instructions on
how to do this.
^ After removing the transport struts (if
this has not already been done by
your fitter) press the OK button.
Setting the time of day
The display for setting the time of day
will appear.
Set time of day
^ Set the hour with the – and + buttons
and confirm your setting by pressing
the OK button. Now set the minutes.
After you have confirmed the minute
setting, the display will change to
show the entry menu.
12: 00
11
Hide quick links:
Advertisement
Table of Contents
