Table of Contents
Advertisement
6. Position the Audiophile 2496 PCI host card over the target PCI slot and fit the
card loosely over it with the card in the upright position. Press the card gently
but firmly downward into the slot until the card is completely and squarely seated
in the slot. If the card seems difficult to seat, a slight rocking motion may help.
7. Fasten the Audiophile 2496 PCI host card's metal bracket down into the screw
hole on the back of your computer using the screw you removed in step 5 above.
8. Place the cover back on your computer.
Now it is time to connect the Audiophile 2496 break-out cable to the PCI card that
you have just installed. Never attach the break-out cable with the computer turned
on. Doing so could damage the PCI card and/or computer, and void your warranty.
Attach the break-out cable to the PCI host card, and secure with the screws that are
molded into the break-out cable.
Audiophile 2496 Driver & Software Installation
The Audiophile 2496 system includes a "Software Drivers CD" (or diskette) for
Windows 98/95/NT and Macintosh, containing all Windows drivers, Macintosh
drivers (including all ASIO drivers), and Delta Control Panel software.
Audiophiles may come with drivers on floppy disk instead. If so, when following the
driver installation procedures outlined below, substitute your computer's floppy drive
letter for the CD's drive letter. To install on your system, please follow these steps:
Windows 98 Installation
1. After installing the Audiophile 2496 hardware, boot your system and start
Windows. During the Windows boot procedure, the new hardware will be
automatically detected by the 'Add New Hardware Wizard', as shown here.
Click 'Next>'.
6
Some
Hide quick links:
Advertisement
Table of Contents
