Before Calling For Service - Panasonic AJ-PCD2GPJ Operating Instructions Manual

Before Calling for Service

■ The access indicator blinks rapidly and the P2 drive does not work.
Connect the USB 2.0 connector (POWER) and the USB 2.0 connector (SIGNAL)
to USB ports on a personal computer using the two supplied USB cables. If the
USB 2.0 connector (POWER) is not connected, the access indicator will blink
rapidly for two seconds and go off for one second. This status repeats.
■ The personal computer does not recognize the P2 drive when it is
connected with the two USB cables.
If they are connected to USB 1.1 ports on the personal computer, reconnect
them to USB 2.0 ports.
If the USB cables are longer than 1.0 m, reconnect using the two supplied 1.0 m
USB cables.
Do not use bus-powered USB hubs but self-powered USB hubs (self-powered
hubs supply their own power via an AC adapter).
■ PCMCIA Type II cards other than P2 cards cannot be used.
The P2 drive is designed for P2 cards and does not support PCMCIA Type II
cards other than P2 cards.
■ P2 cards cannot be accessed after resume from sleep or hibernation.
Some personal computers may not be able to access a P2 card in the P2 drive
after resuming from sleep or hibernation. Should this happen, reconnect the two
USB cables.
E-13