Care And Cleaning; Cleaning Materials; Cleaning The Outside Of The Appliance; Cleaning The Control Knobs And Handles - Electrolux Insight EIKG6046 User Manual

CARE AND CLEANING

Before cleaning always allow the appliance
to cool down before switching off at the
electricity supply.

CLEANING MATERIALS

Before using any cleaning materials on your
appliance, check that they are suitable and that their
use is recommended by the manufacturer.
Cleaners that contain bleach should NOT be used
as they may dull the surface finishes. Harsh
abrasives must also be avoided.
CLEANING THE OUTSIDE OF THE
APPLIANCE
Do not use abrasive cleaning materials e.g. Hob
Brite, Brillo pads or scourers on painted or printed
finishes as damage may occur. Regularly wipe over
the control panel, doors and appliance sides using a
soft cloth and hot soapy water. To prevent streaking
finish with a soft cloth.
Stainless Steel cream cleaners are abrasive and
should be avoided as they may dull the surface
finish. Any spillage on the stainless steel finish
must be wiped off immediately.
Do not attempt to remove any of the
control knobs from the appliance as this
may cause damage and is a safety hazard.
CLEANING THE CONTROL KNOBS AND
HANDLES
It is strongly recommended that only hot soapy water
is used for cleaning the control knobs and handles.
ANY OTHER CLEANING MATERIALS MAY DULL
THE SURFACE FINISH.
REMOVING AND REPLACING THE
WIREWORK RUNNERS
1. Remove all shelves and furniture from the oven.
2. Hold the wirework at the bottom, unclip from the
cavity side and gently pull towards the centre of
the oven.
3. Unhook the runner at the top and remove from
the cavity.
4. To replace the runners, hook the wirework side
runner into the cavity, slide back and press into
place.
Ensure the wirework runners are firmly in
position before replacing the oven
shelves.
SIDE PANEL
22
CAVITY
CENTRE