Economy Operation - Fujitsu ASYA24LCC Operating Manual

10°C HEAT OPERATION
• The room temperature can be maintained at 10°C by pressing the 10°C HEAT button
(Fig.6 M) so as to prevent the room temperature from falling too far.
To use 10°C HEAT OPERATION
Press the 10°C HEAT button (Fig.6 M)
To stop 10°C HEAT OPERATION
Press the START/STOP button (Fig.6 M)
Then the operation stops.
About the 10°C HEAT OPERATION
• The Heating mode will not operate if the room temperature is high enough.

ECONOMY OPERATION

Begin Air Conditioner operation before performing this procedure.
To Use the ECONOMY Operation
Press the ECONOMY button (Fig.6 T).
"ECO" appears on the Remote Controller display.
Economy operation begins.
To Stop the ECONOMY Operation
Press the ECONOMY button (Fig.6 T) again.
"ECO" disappears from the Remote Controller display.
Normal operation begins.
About ECONOMY Operation
At the maximum output, ECONOMY Operation is approximately 70% of normal air conditioner operation for cooling and
heating.
• When ECONOMY operation is performed during the cooling mode, dehumidification is improved. This function is especially
convenient when you want to remove the humidity in the room without significantly lowering the room temperature.
• During ECONOMY operation, the thermostat setting automatically changes according to the temperature to avoid Unneces
sary cooling and heating for the most economical operation.
G If the room is not cooled (or heated) well during economy operation, select normal operation.
G Once air conditioner operation is stopped, normal operation begins when the indoor unit is turned on again.
G During the monitor period in the AUTO mode, the air conditioner operation will not change to ECONOMY operation even if
ECONOMY operation is selected by pressing the ECONOMY operation button.
While 10˚C HEAT OPERATION is in
progress, the following operations/
features cannot be used
• TIMER
• SLEEP
• FAN speed
• Swing
En-10