Alpine MRV-F900 Owner's Manual page 15

3
Slide the battery lead into the fuse block.
• Slide the battery lead (sold separately) into the fuse block (supplied) as below:
1) Dismantle the fuse box.
Turn the cap
1
2) Turn the hexagon screw
3) Remove the rubber ring
protection during transportation.)
4) Slide the battery lead
5) Insert the tip of the battery lead
6) Tighten the hexagon screw
(supplied).
7) Insert the fuse
* Fit the projection
5
** AWG4 or larger
1
4
To the vehicle's battery
4
Turn the hexagon screw of the power terminal. Insert the exposed wire end into
the lead terminal. Tighten the Hexagon screw with the Hexagonal Wrench (In-
cluded), to fix the lead. (Fig. 9)
Before making this connection, use insulated shrink tubing to cover any exposed
wire extending beyond the terminal.
NOTES:
• Use only the Hexagon screws included.
• For safety reasons, connect the battery leads last.
• To prevent disconnection of the leads or dropping of the unit, do not use the cabling to
carry the unit.
counterclockwise.
of the fuse terminal
3
and the metal ring
4
(sold separately) through the cap
5
into the inner part of the fuse terminal
5
of the fuse terminal
3
(80A, supplied) as shown in the illustration below.
6
of the fuse holder
8
3
* Remove 2
10
9
8
Hexagon Screw
Lead
with a hexagon wrench (supplied).
2
. (They are not used. They are for
10
.
1
securely with the hexagon wrench
2
into the grooves of the fuse terminal
7 9
6
7
3
* Remove
8
9
10
4
To the battery terminal
of the product
Lead Terminal
.
2
.
2
2
1
5
** AWG4 or larger
Fig. 8
Fig. 9
11
-
EN