Configuring Jmb362/Gigabyte Sata2 Sata Controller - Gigabyte GA-P55-UD3R User Manual

5-1-2 Configuring JMB362/GIGABYTE SATA2 SATA Controller

A. Installing SATA hard drive(s) in your computer
Attach one end of the SATA signal cable to the rear of the SATA hard drive and the other end to available
SATA port on the motherboard. See the table below for the SATA controllers and their corresponding SATA
ports. Then connect the power connector from your power supply to the hard drive.
B. Configuring SATA controller mode in BIOS Setup
Make sure to configure the SATA controller mode correctly in system BIOS Setup.
Step 1:
Turn on your computer and press <Delete> to enter BIOS Setup during the POST. In BIOS Setup, go to Inte-
grated Peripherals. To enable RAID, see the table below for configuring different SATA Controllers for RAID.
Controller
JMB362
GIGABYTE GSATA2_0/1
SATA2
SATA RAID/AHCI Mode
SATA Port0-3 Native Mode
USB Controllers
USB Legacy Function
USB Storage Function
Azalia Codec
Onboard H/W LAN
Green LAN
 SMART LAN
Onboard LAN Boot ROM
eSATA Controller
eSATA Ctrl Mode
GSATA 0_1/IDE Controller
GSATA 0_1/IDE Ctrl Mode
Onboard Serial Port 1
Onboard Parallel Port
Parallel Port Mode
higf : Move Enter: Select
F5: Previous Values
Step 2:
Save changes and exit BIOS Setup.
The BIOS Setup menus described in this section may differ from the exact settings for your moth-
erboard. The actual BIOS Setup menu options you will see shall depend on the motherboard you
have and the BIOS version.
Connectors BIOS Settings
eSATA ports Set eSATA Controller to Enabled
Set eSATA Ctrl Mode
Set GSATA 0_1/IDE Controller
Set GSATA 0_1/IDE Ctrl Mode
CMOS Setup Utility-Copyright (C) 1984-2009 Award Software
Integrated Peripherals
+/-/PU/PD: Value
F6: Fail-Safe Defaults
to
RAID
to
to
[Disabled]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Auto]
[Enabled]
[Disabled]
[Press Enter]
[Disabled]
[Enabled]
[RAID]
[Enabled]
[RAID/IDE]
[3F8/IRQ4]
[378/IRQ7]
[SPP]
F10: Save
Figure 1
- 91 -
Enabled
RAID/IDE
Item Help
Menu Level 
ESC: Exit F1: General Help
F7: Optimized Defaults
Appendix