Memory Upgrade Module; Installing Memory Upgrade Modules; Removing A Memory Upgrade Module - Fujitsu LifeBook S6000 Manual

Memory Upgrade Module

Your LifeBook notebook comes with a minimum of 256
MB of high speed Double Data Rate 2 Synchronous
Dynamic RAM (DDR SDRAM), DDR2-533 MHz factory
installed. To increase your LifeBook notebook's memory
capacity (up to a maximum of 2 GB), you may install a
larger and/or an additional memory upgrade module.
The memory upgrade must be a dual-in-line (DIMM)
SDRAM module. To ensure 100% compatibility,
purchase the SDRAM module only from the Fujitsu web
store at http://www.computers.us.fujitsu.com
Do not remove any screws from the
■
memory upgrade module compartment
except the ones specifically shown in the
directions for installing and removing the
memory upgrade module.
■ The memory upgrade module can be
severely damaged by electrostatic dis-
charge (ESD). Be sure you are properly
grounded when handling and installing
the module.

INSTALLING MEMORY UPGRADE MODULES

1. Turn off power to your LifeBook notebook and
remove any power adapter (AC or auto/airline).
2. Make sure that all the connector covers are closed.
3. Turn the notebook bottom side up, and remove the
screws of the memory upgrade module compart-
ment. (Figure 4-11)
4. Remove the cover.
Figure 4-11. Opening the Memory Upgrade Compartment
5. Remove the memory upgrade module from the
static guarded sleeve.
6. Align the memory upgrade module with the part
side up. Align the connector edge of the memory
upgrade module with the connector slot in the
compartment.
7. Insert the memory upgrade module at a 45° angle.
Press the connector edge of the module firmly down
and into the connector until it lodges under the
retaining clip. You will hear a click when it is prop-
erly in place. (Figure 4-12)
.
Figure 4-12. Installing a Second Memory Module
8. Replace the cover. (Figure 4-13)
9. Replace the screws.
Figure 4-13. Replacing the Memory Compartment Cover
TO REMOVE A MEMORY UPGRADE MODULE
1. Perform steps 1 through 4 of Installing a Memory
Upgrade Module.
2. Pull the clips sideways away from each side of the
memory upgrade module at the same time.
3. While holding the clips out, remove the module
from the slot by lifting it up and pulling towards the
rear of your notebook. (Figure 4-14)
Figure 4-14. Removing a Memory Upgrade Module
U s e r I n s t a l l a b l e F e a t u r e s
The memory upgrade module is not
something you routinely remove from
your notebook. Once it is installed, you
can leave it in place unless you want to
change system memory capacity.
43