Compass Zone Selection - Honda 2012 Pilot Owner's Manual

Compass Zone Selection

In most areas, there is a variation
between magnetic north and true
north. Zone selection is required so
the compass can compensate for this
variation. To check and select the
zone, do this:
1. Turn the ignition switch to the ON
(II) position.
2. Press and hold the SETUP button
for about 5 seconds. The display
shows you the compass setting
menu items.
3. Turn the selector knob to select
''ZONE'' or ''Zone Adjust.'' Press
the selector knob to enter your
selection. The display shows you
the currently selected zone
number.
U.S. EX and Canadian LX models
EX-L and Canadian EX models
4. Find the zone for your area on the
map (see page 436 ). If the correct
zone is not shown, turn the
selector knob to cycle the zone
lists up or down.
If necessary, press the RETURN
button to return to the previous
display. Pressing the SETUP
button will cancel the compass
setting mode.
Compass
U.S. EX and Canadian LX models
EX-L and Canadian EX models
5. Once the correct zone is displayed,
press the selector knob. The
display then returns to normal.
CONTINUED
435