Assembly And Operation; Applications; Removal And Installation Method Of Battery; Charging Method - Hitachi DN12DYK Instruction Manual

English

ASSEMBLY AND OPERATION

APPLICATIONS

Use as a drill
Drilling of soft steel, wood, plastic and aluminum materials.
Use as a screwdriver
Tightening and loosening of wood screws and tapping screws.

REMOVAL AND INSTALLATION METHOD OF BATTERY

Handle
Insert
Pull out
Battery
Fig. 3

CHARGING METHOD

NOTE: Before plugging into the receptacle, make sure the following points.
The power source voltage is stated on the nameplate.
The cord is not damaged.
WARNING:
14
Push
Latch
Do not charge at voltage higher than indicated on the nameplate.
If charged at voltage higher than indicated on the nameplate, the
charger will burn up.
How to install the battery.
Align the battery with the groove in tool handle
and slip it into place.
Always insert it all the way until it locks in place
with a little click, If not, it may accidentally fall
out of the tool, causing injury to you or
someone around you. (Fig. 3)
How to remove the battery.
Withdraw battery from the tool handle while
pressing the latch on the side of the battery.
(Fig. 3)