Hawkeye Mfg D10D Installation & Operation Manual page 4

3. Cut out the 2-inch hole using the 2" hole saw.
4. Seal any exposed wood with a marine sealant.
5. Insert the display from the front of the panel, feed
the wires through the bracket and install the
bracket and locking nut from the rear of the
panel. Make sure that the face of the display is
rotated upright and aligned to your satisfaction for
easy viewing from the vessel's helm.
extension rod to the mounting stud on the back of the display housing
before inserting the display into the Surface Mount Bracket.
STEP 2
Installing the Face and Bezel
1. Place the face (B) over the display making
sure to line up the cut outs on the face with
the notches on the display.
2. While holding the bezel (A), place it over
the display and turn clockwise until the
bezel locks into place.
Gold and Chrome Alloy Bezels can be purchased on our
website to match your factory dash or give your Digital Depth
Sounder a custom appearance (P/N: 1000.20, 1000.22).
STEP 3
Connecting of the Power Cable
The display has no ON/OFF switch. Therefore, you will need to
connect the power harness to a power source that will turn the
unit on as power is applied. The key switch or an ON/OFF
power switch will be suitable for powering the unit.
1. Connect the BLACK wire in the harness to a negative (-)
terminal or suitable ground.
w w w . h a w k e y e e l e c t r o n i c s . c o m
N
OTICE
The display can also be surface mounted using
the Adjustable Surface Mount Bracket (1000.10).
Please visit our website or contact us by phone
for purchase information. You must attach the
N
OTICE
:
: