Installing The Display - Hawkeye Mfg D10D Installation & Operation Manual

•
Shallow draft boats to prevent accidental damage to the transducer from
intentional or unintentional ground.
•
NON-CORED hulls or aluminum hulls thinner than 1/8".
•
Inboard vessels that have a lot of running gear that creates significant
turbulence.
Glue-in mounting of the transducer is NOT suitable for all
vessels. You MUST test the glue-in location on the water prior
to using epoxy to permanently affix it to the hull. If you cannot
obtain satisfactory readings during on water testing you will need to
transom mount the transducer, or switch to a customized transducer.
If you think that the included transducer is not suitable for your installation, return
to the place of purchase and exchange it for the correct transducer. You can
also visit our Customer Service Center at www.hawkeyelectronics.com to contact
us or to complete a transducer exchange request to exchange the transducer for
one that is specialized for your vessel. You may also call 888-766-7276 to
inquire about exchanging the transducer.

INSTALLING THE DISPLAY

Tools & Supplies Required for Installation
•
Electric Drill
•
2" Hole Saw
•
Wire Connectors Suitable for Connecting the Power Wire to Your Vessel
•
Wire Cutting/Crimping Tool
•
Marine Sealant/Caulk
STEP 1
Installing the Display
1. Find a location on the boat that will allow clear viewing of the display. Keep
in mind that the wires for the transducer and power must reach the mounting
location.
2. After finding the right location, mark a 2-inch hole. (If your boat has a pre-cut
hole in the dash panel, simply remove the hole plug and proceed to Step 5.)
Check behind the desired cutting area for wires, switches, etc. that
may be damaged during cutting. If these obstructions are present,
use masking tape to hold them out of the way during cutting.
w w w . h a w k e y e e l e c t r o n i c s . c o m
N :
OTICE
I :
MPORTANT