Gigabyte GA-P61-USB3-B3 User Manual page 78

B. Configuring SATA controller mode in BIOS Setup
Make sure to configure the SATA controller mode correctly in system BIOS Setup.
Step 1:
Turn on your computer and press <Delete> to enter BIOS Setup during the POST. In BIOS Setup, go to In-
tegrated Peripherals. To enable RAID, set GSATA3 Controller to Enabled and set GSATA3 Ctrl Mode to
RAID.
CMOS Setup Utility-Copyright (C) 1984-2011 Award Software
SATA Port0-1 Native Mode
USB Controllers
USB Legacy Function
USB Storage Function
Azalia Codec
Onboard H/W LAN
 SMART LAN
Onboard LAN Boot ROM
Onboard USB3.0 Controller
GSATA3 Controller
GSATA3 Ctrl Mode
Onboard Serial Port 1
Onboard Parallel Port
Parallel Port Mode
higf: Move Enter: Select
F5: Previous Values
Step 2:
Save changes and exit BIOS Setup.
The BIOS Setup menus described in this section may differ from the exact settings for your moth-
erboard. The actual BIOS Setup menu options you will see shall depend on the motherboard you
have and the BIOS version.
Appendix
Integrated Peripherals
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Auto]
[Enabled]
[Press Enter]
[Disabled]
[Enabled]
[Enabled]
[RAID]
[3F8/IRQ4]
[378/IRQ7]
[SPP]
+/-/PU/PD: Value F10: Save
F6: Fail-Safe Defaults
Figure 1
- 78 -
Item Help
Menu Level 
ESC: Exit F1: General Help
F7: Optimized Defaults