GSATA3 Controller (Marvell 88SE9172 Chip, GSATA3_4 and GSATA3_5 connectors) j
Enables or disables the SATA controller integrated in the Marvell 88SE9172 chip. (Default: Enabled)
GSATA3 Ctrl Mode (Marvell 88SE9172 Chip, GSATA3_4 and GSATA3_5 connectors) j
Enables or disables RAID for the SATA controller integrated in the Marvell 88SE9172 chip or configures
the SATA controller to AHCI mode.
IDE
Configures the SATA controller to IDE mode. (Default)
AHCI
C onfigures the SATA controller to AHCI mode. Advanced Host Controller Interface (AHCI)
is an interface specification that allows the storage driver to enable advanced Serial ATA
features such as Native Command Queuing and hot plug.
RAID
Enables RAID for the SATA controllers.
Onboard Serial Port 1
Enables or disables the serial port and specifies its base I/O address and corresponding interrupt.
Options are: Auto, 3F8/IRQ4 (default), 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3, Disabled.
Onboard Parallel Port
Enables or disables the onboard parallel port (LPT) and specifies its base I/O address and correspond-
ing interrupt. Options are: 378/IRQ7 (default), 278/IRQ5, 3BC/IRQ7, Disabled.
Parallel Port Mode
Selects an operating mode for the onboard parallel (LPT) port. Options are: SPP (Standard Parallel Port)
(default), EPP (Enhanced Parallel Port), ECP (Extended Capabilities Port), ECP+EPP.
j Only for GA-PA65-D3-B3.
- 47 -
BIOS Setup