Adjusting The Direction Of Air Circulation; Swing Operation - Fujitsu Inverter ASTA07JEC Operating Manual

ADJUSTING THE DIRECTION OF AIR CIRCULATION

Vertical (up-down) direction of airflow is adjusted by pressing the Remote Control Unit's SET button. Horizontal (right-left)
airflow direction is adjusted manually, by moving the Air Flow Direction Louvers.
Whenever making horizontal airflow adjustments, start air conditioner operation and be sure that the vertical air direction
louvers are stopped.
Vertical Air Direction Adjustment
Press the SET button (Fig. 6 R).
Each time the button is pressed, the air direction range will change as follows:
1
Types of Air flow Direction Setting:
1,2,3 :
During Cooling/Dry modes
1,2,3,4,5,6 :During Fan mode
The Remote Control Unit's display does
not change.
● Use the air direction adjustments within the ranges shown above.
● The vertical airflow direction is set automatically as shown, in accordance with
the type of operation selected.
During Cooling/Dry/Fan mode : Horizontal flow 1
● During AUTO mode operation, for the first one minute after beginning operation,
airflow will be horizontal 1; the air direction cannot be adjusted during this pe-
riod.
Right-Left Adjustment
Adjust the Right-Left louvers.
● Move the Right-Left louvers to adjust air flow in the direction you prefer.
knob(two places)

SWING OPERATION

Begin air conditioner operation before performing this procedure.
To select SWING Operation
Press the SWING button (Fig. 6 S).
The SWING Display (Fig. 7 ]) will light.
In this mode, the Air Flow Direction Louvers will swing automatically to direct the
air flow both up and down.
To stop SWING Operation
Press the SWING button (Fig. 6 S) once again.
The SWING Display (Fig. 7 ]) will go out.
Airflow direction will return to the setting before swing was begun.
About Swing Operation
● The SWING operation may stop temporarily when the air conditioner's fan is not
operating, or when operating at very low speeds.
● The range of swing is relative to the currently set airflow direction.
During Cooling/Dry mode : Swings between 1 and 3.
During Fan mode
2 3 4 5
Right-Left Louvers
knob
: Swings between 1 and 3 or 3 and 6.
● Never place fingers or foreign objects in-
6
R DANGER!
● When adjusting the Right-Left Louvers, it
R DANGER!
side the outlet ports, since the internal fan
operates at high speed, and personal in-
jury could be caused.
● Always use the Remote Control Unit's
SET button to adjust the vertical airflow
louvers. Attempting to move them
manually could result in improper op-
eration; in this case, stop operation and
restart. The louvers should begin to
operate properly again.
● During use of the Cooling and Dry
modes, do not set the Airflow Direc-
tion Louvers in the range (4 - 6) for
many hours, since water vapor may
condense near the outlet louvers and
drops of water may drip from the in-
door unit. During the Cooling and Dry
modes, if the Airflow Direction Louvers
are left in the range (4 - 6) for more
than 30 minutes, they will automati-
cally return to position 3.
● When used in a room with infants, chil-
dren, elderly or sick persons, the airflow
direction and room temperature should
be considered carefully when making
settings.
is necessary to stop the Air-Conditioner
first and make sure that it stops completely
before adjusting the direction.
En-10