Sleep Timer Operation; Manual Auto Operation - Fujitsu Inverter ASTA07JEC Operating Manual

SLEEP TIMER OPERATION

Unlike other timer functions, the SLEEP timer is used to set the length of time until air conditioner operate is stopped.
To Use the SLEEP Timer
While the air conditioner is operating or stopped, press the
SLEEP button (Fig. 6 M).
The indoor unit's OPERATION Indicator Lamp (green) (Fig. 3 5) lights and the TIMER
Indicator Lamp (orange) (Fig. 3 6) light.
To Change the Timer Settings
Press the SLEEP button (Fig. 6 M) once again and set the time
using the TIMER SET (
Set the time while the Timer Mode Display is flashing (the flashing will continue
about five seconds).
button: Press to advance the time.
button: Press to reverse the time.
About five seconds later, the entire display will reappear.
About the SLEEP Timer
To prevent excessive cooling during sleep, the SLEEP timer function automatically modifies the thermostat setting in accord-
ance with the set time setting. When the set time has elapsed, the air conditioner completely stops.
During Cooling/Dry operation:
When the SLEEP timer is set, the thermostat setting is automatically raised 1 °C every sixty minutes. When the thermostat has
been raised a total of 2 °C, the thermostat setting at that time is maintained until the set time has elapsed, at which time the air
conditioner automatically turns off.

MANUAL AUTO OPERATION

Use the MANUAL AUTO operation in the event the Remote Control Unit is lost or otherwise unavailable.
How To Use the Main Unit Controls
Press the MANUAL AUTO button (Fig. 2 2) for three seconds
on the main unit control panel.
To stop operation, press the MANUAL AUTO button (Fig. 2 2) for three seconds.
En-9
) buttons (Fig. 6 T).
/
SLEEP timer setting
Set time
1 hour
1 °C
To Cancel the Timer:
Use the TIMER MODE button to select
"CANCEL".
The air conditioner will return to normal
operation.
To Stop the Air Conditioner During
Timer Operation:
Press the START/STOP button.
2 °C
● When the air conditioner is operated
by the controls on the Main Unit, it will
operate under the same mode as the
AUTO mode selected on the Remote
Control Unit (see page 6).
● The fan speed selected will be "AUTO"
and the thermostat setting will be
standard (24
°C
).