Display Panel; Opening The Display Panel; Adjusting Display Panel Brightness; Closing The Display Panel - Fujitsu LifeBook C series Owner's Manual

L i f e B o o k C S e r i e s – S e c t i o n T h r e e
Display
Panel
Latch

Display Panel

Your Fujitsu LifeBook notebook contains a display panel
that is backlit for easier viewing in bright environments
and maintains top resolution through the use of active-
matrix technology.

OPENING THE DISPLAY PANEL

1. Slide the latch located at the top of the display panel
to the right. This releases the locking mechanism
and raises the display slightly.
2. Lift the display backwards, being careful not to
touch the screen, until it is at a comfortable
viewing angle.

ADJUSTING DISPLAY PANEL BRIGHTNESS

Once you have turned on your LifeBook notebook, you
may want to adjust the brightness level of the screen to a
more comfortable viewing level. There are two ways to
adjust the brightness, keyboard and power management
utility.
P O I N T
The higher the brightness level, the more power the
LifeBook notebook will consume and the faster your
batteries will discharge. For maximum battery life, set
the brightness to as low a level as possible.
Keyboard
Adjusting the brightness using the keyboard changes the
setting only temporarily.
[Fn+F6]: Pressing repeatedly will lower the
I
brightness of your display.
[Fn+F7]: Pressing repeatedly will increase the
I
brightness of the display.
26
Figure 3-2 Opening the Display Panel
If using AC power, your brightness setting is set to its
highest level by default. If using battery power, your
brightness settings is set to approximately mid-level by
default.

CLOSING THE DISPLAY PANEL

1. Holding the edge of your display panel, pull it
forward until it is flush with the body of your
LifeBook notebook.
2. Push down until you hear a click. This will engage
the locking mechanism and prevent your display
panel from opening unexpectedly.
P O I N T