Changing A Fuse - Focusrite Green Range Manual

v o i c e b o x

Changing a Fuse

We strongly recommend that you do NOT attempt to change fuses unless you are
absolutely certain that you know exactly what you are doing. If you are in any doubt
whatsoever, contact your dealer or the factory before you open the module.
To change a fuse, if you are certain of your technical ability:
1. Disconnect the mains cable.
2. Viewing the module from the back, remove the four screws that secure the back
panel (there are two at each end).
3. Carefully slide out the inside of the unit with a downward motion. (see diagram)
Chassis Sleeve
PCB
Rear
Front PCB
4. The fuse is in a holder close to the transformer. To remove the fuse, pull off the
top of the fuse holder, which holds the fuse.
5. Replace the fuse with a 250 mA anti-surge type.
6. When you have replaced the fuse, slide the inside of the unit back into the
outer cover.
7. Replace the four screws in the back panel.
20