Advanced Setup - ECS G41T-M6 Manual

30

Advanced Setup

This page sets up more advanced information about your system. Handle this page
with caution. Any changes can affect the operation of your computer.
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
Thermal Management
TM Status
Limit CPUID MaxVal
Enhanced Halt (C1E)
Intel XD Bit
Intel Virtualization Technol
Intel EIST
Quick Power on Self Test
Boot Up Numlock Status
APIC Mode
1st Boot Device
2nd Boot Device
3rd Boot Device
Hard Disk Drives
Boot Other Device
ECS eJIFFY Function
Thermal Management (Enabled)
This item displays CPU's temperature and enables you to set a safe temperature to
Prescott CPU.
TM Status (TM1/TM2)
This item shows TM function status if CPU can support TM function.
Limit CPUID MaxVal (Disabled)
Use this item to enable or disable the Max CPU ID value limit. When supports
Prescott and LGA775 CPUs, enables this to prevent the system from "rebooting"
when trying to install Windows NT 4.0.
Enhanced Halt (C1E) (Enabled)
This item enables or disables enhanced halt (C1E).
Intel XD Bit (Disabled)
This item allows users to enable or disable the Intel XD bit.
Intel Virtualization Technol (Enabled)
Hardware Virtualization Technology enables processor feature for runningmultiple
simultaneous Virtual Machines allowing specialized softwareapplications to run in
full isolation of each other.
Intel EIST (Enabled)
This item allows users to enable or disable the EIST
technology).
Quick Power on Self Test (Enabled)
Enable this item to shorten the power on testing (POST) and have your system start
up faster. You might like to enable this item after you are confident that your system
hardware is operating smoothly.
Advanced Setup
Enabled
TM1/TM2
Disabled
Enabled
Disabled
Enabled
Enabled
Enabled
On
Enabled
Hard Disk Drive
CD/DVD
Removable Dev.
Press Enter
Yes
Disabled
: Move Enter : Select +/-/: Value
F1: General Help F9: Load Default Settings
Using BIOS
Help Item
For the processor its
CPUID belows 0F41h.
TM2 only can be enable
under below setting.
1.Freq.>=3.6GHz FSB800
2.Freq.>=2.8GHz FSB533
F10: Save ESC: Exit
(Enhanced Intel SpeedStep