Table of Contents
Advertisement
2. Switch Serial Number
3. World Wide Name (WWN)
Document feedback
Quality is our first concern at Brocade and we have made every effort to ensure the accuracy and
completeness of this document. However, if you find an error or an omission, or you think that a
topic needs further development, we want to hear from you. Forward your feedback to:
Provide the title and version number of the document and as much detail as possible about your
comment, including the topic heading and page number and your suggestions for improvement.
PowerConnect B-8000 Hardware Reference Manual
53-1001788-01
•
Detailed description of the problem, including the switch or fabric behavior immediately
following the problem, and specific questions
•
Description of any troubleshooting steps already performed and the results
•
Serial console and Telnet session logs
•
syslog message logs
The switch serial number and corresponding bar code are provided on the serial number label,
as illustrated below.:
*FT00X0054E9*
FT00X0054E9
The serial number label is located as follows:
•
PowerConnect B-200E—On the non-port side of the chassis
•
PowerConnect B-300, 4100, 4900, 5100, 5300, 7500, 8000, and Brocade Encryption
Switch—On the switch ID pull-out tab located inside the chassis on the port side on the left
•
PowerConnect B-5000—On the switch ID pull-out tab located on the bottom of the port
side of the switch
•
PowerConnect B-7600—On the bottom of the chassis
•
PowerConnect B-48000—Inside the chassis next to the power supply bays
•
PowerConnect B-DCX—On the bottom right on the port side of the chassis
Use the wwn command to display the switch WWN.
If you cannot use the wwn command because the switch is inoperable, you can get the WWN
from the same place as the serial number, except for the PowerConnect B-DCX. For the
PowerConnect B-DCX, access the numbers on the WWN cards by removing the Brocade logo
plate at the top of the non-port side of the chassis.
documentation@brocade.com
xi
Advertisement
Table of Contents
