Installing Memory Modules - ECS G41T-M12 Manual

12

Installing Memory Modules

This motherboard accommodates two memory modules. It runs at dual-channel
DDR3 1066/800MHz memory speed. The total memory capacity is 8 GB.
DDR3 SDRAM memory module table
Memory module
DDR3 800
DDR3 1066
You must install at least one module in any of the two slots.
Do not remove any memory module from its antistatic packaging until
you are ready to install it on the motherboard. Handle the modules
only by their edges. Do not touch the components or metal parts.
Always wear a grounding strap when you handle the modules.
Installation Procedure
Refer to the following to install the memory modules.
1 This motherboard supports unbuffered DDR3 SDRAM .
2 Push the latches on each side of the DIMM slot down.
3 Align the memory module with the slot. The DIMM slots are keyed with
notches and the DIMMs are keyed with cutouts so that they can only be
installed correctly.
4 Check that the cutouts on the DIMM module edge connector match the
notches in the DIMM slot.
5 Install the DIMM module into the slot and press it firmly down until it
seats correctly. The slot latches are levered upwards and latch on to
the edges of the DIMM.
6 Install any remaining DIMM modules.
Memory Bus
400 MHz
533 MHz
Installing the Motherboard