ECS G41T-M7 Manual page 35

Boot Up Numlock Status (On)
This item defines if the keyboard Num Lock key is active when your system is
started.
APIC Mode (Enabled)
This item allows you to enable or disable the APIC (Advanced Programmable Inter-
rupt Controller) mode. APIC provides symmetric multi-processing (SMP) for sys-
tems, allowing support for up to 60 processors.
1st/2nd/3rd Boot Device (Hard Disk Drive/CD/DVD/Removable Dev.)
Use this item to determine the device order the computer used to look for an
operating system to load at start-up time. The devices showed here will be different
depending on the exact devices installed on your motherboard.
Hard Disk Drives (Press Enter)
Scroll to this item and press <Enter> to view the following screen:
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
Hard Disk Drives
1st Drive
CD/DVD Drivers (Press Enter)
Scroll to this item and press <Enter> to view the following screen:
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
CD/DVD Drivers
1st Drive
Press <Esc> to return to the Advanced Setup page.
Hard Disk Drives
ST3160023AS
: Move Enter : Select
+/-/: Value
F1: General Help
CD/DVD Drivers Drives
TSSTcorpDVD-ROM TS-
: Move Enter : Select
+/-/: Value
F1: General Help
Using BIOS
Specifies the boot
sequence from the
available devices.
F10: Save ESC: Exit
F9: Load Default Settings
Specifies the boot
sequence from the
available devices.
F10: Save ESC: Exit
F9: Load Default Settings
Help Item
Help Item
31