Checking Jumper Settings; Jumper Settings - ECS G41T-M7 Manual

Checking Jumper Settings

The following illustration shows the location of the motherboard jumpers. Pin 1 is
labeled.

Jumper Settings

Jumper Type
CLR_CMOS 3-pin CLEAR CMOS
3-pin
USBPWR_R
USBPWR_F 3-pin
To avoid the system instability after clearing CMOS, we recommend
1.
users to enter the main BIOS setting page to "Load Default Settings"
and then "Save & Exit Setup".
2. Make sure the power supply provides enough 5VSB voltage before se-
lecting the 5VSB function.
3. It is required that users place the USBPWR_F1~2 & USBPWR_R1 cap
onto 2-3 pin rather than 1-2 pin as default if you want to wake up the
computer by USB/PS2 KB/Mouse.
Description
1-2: NORMAL
2-3: CLEAR
Before clearing the
CMOS, make sure to
turn the system off.
Rear USB/PS2
Power Select
Jumper
Front Panel
USB Power
Select Jumper
Installing the Motherboard
Setting (default)
1-2: VCC
2-3: 5VSB
1-2: VCC
2-3: 5VSB
1
CLR_CMOS
1
USBPWR_R
1
USBPWR_F
9