Table of Contents
Advertisement
Acer d100 fundamentals
If the battery level becomes low in the course of normal use, recharge the
device. Normally, you can use the AC adapter to recharge your Acer d100
series. However, this may be difficult when there's no available AC power
outlet on hand. When your device battery is drained while on the road, you
can still recharge your device by using either the car charger cable or the
USB cable bundled with your device. Recharging time from empty to full
capacity is about six (6) hours in all cases.
To recharge the device using the AC adapter:
1. Plug the AC adapter into any AC current outlet.
2. Connect the AC adapter cord to the power connector
panel of the device.
The power LED indicator lights up orange during charging. The hot keys
backlight is also lit up.
3. Once charging is complete, as indicated when the power LED indicator
lights up green, disconnect the AC adapter cord from the device.
To recharge the device using the car charger:
Use the car charger to recharge your device while it is mounted on your
vehicle. Perform step 7 of the
for instructions.
26
If the battery level reaches very low status, the device will automatically turn off. In this
case, you have about 12 hours to recharge your device after which you risk losing all
data on the device's internal memory. In case all data is lost, the next time you power
on the device you will be prompted to restore the data.
"To set up the device on your
on the left
vehicle" section
Acer d100 Portable Navigator
Advertisement
Table of Contents
