Advertisement
Supported Board/Software Guidelines
Board
OE 3.5
Quantum
Yes
Triton Analog Extension
No
Triton Analog Trunk
No
Triton T1/PRI
Yes
Triton T1/E1 PRI
No
Triton VoIP-8
No
Triton VoIP-4
Yes
Triton Resource
No
Installation Procedures
Physical Board ID Arrangement
Each board has its own set of board IDs. It is recommended that you assign each
board a unique ID.
•
Quantum 0–F (ID "0" cannot be used in Windows 2000 server)
•
Triton T1/PRI 0–3 (0–5 is only supported in OE 4.5)
•
Triton T1/E1 PRI 0–3 (0–5 is only supported in OE 4.5)
•
Triton Resource 0–1
•
Triton VoIP 0–5
•
Triton Analog Extension (12 extensions) 0–F
•
Triton Analog Trunk 0–F
MVIP Clock and Termination
Note: Termination point is not related to board ID.
1. Always terminate both ends of the MVIP bus by closing the MVIP bus switch
on the end point boards, regardless of the type of boards in the system. All other
boards should be set in the open position. Do not have any board terminated in
the middle of the MVIP bus, as this will cause an MVIP bus clocking error.
2. Run the MVIP bus test tool every time you add or remove new boards.
Configuration Tip
If your system has multiple T1/PRI or T1/E1 PRI boards, always use the board
connected to the CO as MVIP clock reference. Ensure that your system is not
referenced to the T1 or T1/E1 PRI board that is not connected to the CO. This may
require changing the MVIP clock setting from automatic to manual, and selecting
the board number connected to the CO currently in service.
Note: Handle the boards with care, and use the appropriate electrostatic
discharge (ESD) protection. Mishandling can cause damage to the
boards.
OE 4.0
OE 4.OA
OE 4.0i
Yes
Yes
No
Yes
Yes
Yes
No
Yes
Yes
Yes
Yes
No
No
No
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
OE 4.5
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Advertisement
