Advertisement
Installation Notes
•
Observe proper board handling procedures (refer to AltiGen Field Alert #67).
•
Pre-installation of boards is recommended over on-site installations.
•
Although boards are factory tested prior to shipping, it is recommended that you
follow a burn-in period of approximately 12 hours minimum before an on-site
deployment.
•
Always observe personal safety procedures.
•
Persons performing the installation should observe proper grounding
requirements so as to prevent electrostatic discharge (ESD) damage to the
equipment.
•
Do not remove boards from their protective anti-static bags until the boards are
ready to be installed.
•
If your system has multiple T1/PRI or T1/E1 PRI boards, always use the board
connected to the CO as the MVIP clock reference. Ensure that your system is not
referenced to the T1 or T1/E1 PRI board that is not connected to the CO. This may
require changing the MVIP clock setting from automatic to manual, and selecting
the board number connected to the CO currently in service.
•
(Triton Analog Only) The audio input and first extension share the same physical
port. The first extension port cannot be used as a physical extension when this
board is assigned as a music on hold input board. The audio input port is a 3.5mm
phone jack connector, with a 20k ohm impedance.
•
5.0A Update 2 (or later) software MUST be installed prior to installing the 8-port
Triton Analog Trunk board (ALTI-TTAT-8). If this hardware is installed prior to
the Update 2 software, the system will hang-up/freeze during boot up every time.
To obtain the latest 5.0A update, download from the AltiGen Dealer web site at
https://dealer.altigen.com, or contact AltiGen Technical Support for more
information.
Advertisement
