Useful Functions; Scan Modes; Vfo-Scan; Memory-Scan - Alinco DJ-S47 E Instruction Manual

5.Useful Functions

5. Useful Functions
5.1

Scan Modes

The scan function automatically searches the receiving signals. There are 2 modes for
scan-resume condition.
• Timer Scan
(default)
• Busy Scan: The scan stops when a signal is detected, stays until the signal is gone
During scanning, the 1MHz decimal point ( ) on the frequency display flashes.
Press any key other than the MONI key to stop scanning.
Scanning starts in the direction of the last dial operation (up or down).
NOTE:
5
Please refer to the Set mode to switch the setting between Timer and Busy scan modes
(page 43).

5.1.1 VFO-Scan

1. Press the
2. Press the
accordance with the order of one step.
3. Rotate the dial clockwise/counter-clockwise to change the scan direction.
VFO-scan scans the entire frequency range.
4. Press any key other than the MONI key to stop scanning.

5.1.2 Memory-Scan

1. Press the
2. Press the
3. Rotate the dial clockwise/counter-clockwise to change the scan direction.
Memory-scan scans all programmed memory channels.
4. Press any key other than the MONI key to stop scanning.
NOTE:
Please set the squelch level correctly before scanning, even in the TSQ scanning the
normal squelch level adjustment is required to activate this function.
32
: The scan stops when a signal is detected, and resumes scanning after 5
seconds regardless of receiving status.
then resumes scanning.
key to select the VFO mode.
key for more than 2 seconds to start scanning. The unit scans in
key to select the Memory mode.
key for more than 2 seconds to start memory scanning.