Connection Procedure - Blaupunkt MONTREAL CD34 Manual

High-power fm/am/cd receiver with detachable face
Hide thumbs Also See for MONTREAL CD34:
Table of Contents

Advertisement

Available languages

Available languages

Connections
Warning
• To prevent short circuit, remove the key from the ignition
and disconnect the battery's (-) terminal.
• This unit is designed for negative ground 12 V DC operation
only. You can not use it for 24 V or other types of car batter-
ies.

Connection procedure

Caution
• DO NOT connect any speaker wires to the metal body or
chassis of the vehicle.
• DO NOT connect the speaker common (-) wires to each
other.
• Connect each speaker wire directly to each speaker termi-
nal.
• All speaker common (-) wires must remain floating.
ie. No common connections or connection to vehicle grd.
• Connect each pair of speaker leads only to a single speaker
(or speaker system) that has an impedance of least 4 ohms,
as well as adequate power-handling capability.
• Do not connect speaker leads to any inputs on external
amplifiers. This will cause damage to the internal amplifier
of this unit.
1
Make sure the car's ignition key has been removed.
2
Disconnect the negative(-) terminal of the car's bat-
tery.
3
Connect the wiring harness wires in the following
order : Ground wire (Black), +12V Constant Power
Supply (Yellow), +12V Accessory/Switched (Red) and
Power Antenna/Amplifier Turn On (Blue), and tape
each so they do not come in contact with each other.
4
Connect the speaker wires of the wiring harness.
5
Connect the car's antenna terminal to the antenna
socket of the unit.
6
Connect the detachable wire harness to the unit.
7
Reconnect the negative(-) terminal of the car's bat-
tery.
8
Start the car's engine.
9
Make sure the unit operates properly.
E-10
Connection procedure
Preamp Out/Line Out Connections
• Since this unit has Line Level Outputs, you can use an amplifier to upgrade your vehicle stereo system.
White (Left)
Red (Right)
RCA Line-out Jacks
RCA Line-out Jacks (For Rear Speakers)
• Connect a patch cable (not supplied) from the White (left rear channel) and Red (right rear channel) RCA line output jacks of
the unit to the line input terminals of the external amplifier.
RCA AUX IN Jacks
External Amplifier
Rear Speaker

Advertisement

Table of Contents
loading

Table of Contents