Check Damper Operation; Mount Microwave Oven - Electrolux Over The Range Microwave Oven Installation Instructions Manual

AFTER: Fan Blade Openings
Facing Upward
5.
Place the blower unit back into the opening.
CAUTION: Do not pull or stretch the blower unit
wiring. Make sure the wires are not pinched.
6.
Secure blower unit to microwave with the screw.
B4.
INSTALLATION PROCEDURE FOR
EXHAUST ADAPTOR AND
PROPER DAMPER OPERATION
CHECK
1.
Remove and save screw
from the panel-outer
Exhaust Adaptor and Damper is shipped
after being assembled to the filler-upper.
2.
Slide exhaust adaptor following the instructions
show in diagram.
3.
Make sure tape securing damper is removed and
damper pivots easily before mounting microwave.
4.
Lift damper and Re-screw at same location as (1).
• You will need to make adjustments to assure
proper alignment with your house exhaust duct
after the microwave is installed.
Installation Instructions
B5.
FOR EASIER INSTALLATION AND PERSONAL
SAFETY, WE RECOMMEND THAT TWO PEOPLE
INSTALL THIS MICROWAVE OVEN.
IMPORTANT: Do not grip or use handle during
installation.
NOTE: If your cabinet is metal, use the nylon
grommet around the power cord hole to prevent
cutting of the cord.
NOTE: We recommend using filler blocks if the
cabinet front hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are not used, case
damage may occur from over tightening screws.
NOTE: When mounting the microwave oven, thread
power cord through hole in bottom of top cabinet.
Keep it tight throughout Steps 1–3. Do not pinch cord
or lift oven by pulling cord.
2.
Rotate front of oven up
against cabinet bottom
3.
Insert a self-aligning screw through top center
cabinet hole. Temporarily secure the oven by
turning the screw at least two full turns after the
threads have engaged. (It will be completely
tightened later.) Be sure to keep power cord
tight. Be careful not to pinch the cord,
especially when mounting flush to bottom of
cabinet.
16
MOUNT THE MICROWAVE OVEN
1.
Lift microwave, tilt it
forward, and hook slots
at back bottom edge
onto four lower tabs of
mounting plate.