For Wireless Network Users - Brother HL-3140CW Quick Setup Manual

For Wireless Network Users

f
Temporarily connect the USB cable (not
included) directly to the computer and the
machine.
g
Do one of the following:
 If the Installation confirmation screen
appears, check the box and click Next, and
then go to h.
 If the Installation confirmation screen
does not appear, go to i.
h
Check Yes if you want to connect with the listed
SSID. Click Next, and then go to k.
i
The wizard will search for available wireless
networks from your machine. Choose the SSID
that you wrote down for your network in step
10-a on page 18, and then click Next.
NOTE
• If the list is blank, check that the wireless access
point/router has power and is broadcasting the
SSID. See if the machine and the wireless
access point/router are within range for wireless
communication. Click Refresh.
• If your wireless access point/router is set to not
broadcast the SSID, manually add it by clicking
the Advanced button. Follow the on-screen
instructions for entering the Name(SSID), and
then click Next.
j
Enter the Network Key you wrote down in step
10-a on page 18, and then click Next.
NOTE
If your network is not configured for Authentication
and Encryption, the ATTENTION! screen will
appear. To continue configuration, click OK.
k
Confirm the wireless network settings, and
then click Next. The settings will be sent to your
machine.
NOTE
• The settings will remain unchanged if you click
Cancel.
• To manually enter the IP address settings of
your machine, click Change IP Address and
enter the necessary IP address settings for your
network.
• If the wireless setup failure screen appears,
click Retry.
l
Disconnect the USB cable between the
computer and the machine, and then click Next.
Wireless setup is now complete.
A four-level indicator at the right of your
machine's LCD will show the wireless
signal strength of your wireless access
point/router.
To install the printer driver, continue to
step 13.
®
For Windows Users:
Now go to
step13-e on page 28
For Macintosh Users:
Now go to
step 13-d on page 30
21