Cpu Configuration - ASROCK ConRoe945G-DVI User Manual

Main Advanced
Advanced Settings
WARNING : Setting wrong values in below sections
may cause system to malfunction.

CPU Configuration

Chipset Configuration
ACPI Configuration
IDE Configuration
PCIPnP Configuration
Floppy Configuration
SuperIO Configuration
USB Configuration
v02.54 (C) Copyright 1985-2005, American Megatrends, Inc.
Setting wrong values in this section may cause
the system to malfunction.
3.3.1 3.3.1 CPU Configuration 3.3.1 CPU Configuration CPU Configuration CPU Configuration
3.3.1 3.3.1 CPU Configuration
Advanced
CPU Configuration
Overclock Mode
CPU Frequency (MHz)
PCIE Frequency (MHz)
Boot Failure Guard
Spread Spectrum
Ratio Status
Ratio Actual Value
Ratio CMOS Setting
Enhance Halt State
Max CPUID Value Limit
Intel (R) Virtualization tech.
CPU Thermal Throttling
No-Excute Memory Protection
Hyper Threading Technology
Intel (R) SpeedStep(tm) tech.
v02.54 (C) Copyright 1985-2005, American Megatrends, Inc.
Overclock Mode
Use this to select Overclock Mode. The default value is [Auto]. Cnfiguration
options: [Auto], [CPU, PCIE, Sync.] and [CPU, PCIE, Async.].
CPU Frequency (MHz)
Use this option to adjust CPU frequency. The default value is [133].
PCIE Frequency (MHz)
Use this option to adjust PCIE frequency. The default value is [100].
Boot Failure Guard
Enable or disable the feature of Boot Failure Guard.
Spread Spectrum
This item should always be [Auto] for better system stability.
Ratio Status
This is a read-only item, which displays whether the ratio status of this
motherboard is "Locked" or "Unlocked". If it shows "Unlocked", you will find
2 8 2 8 2 8
2 8 2 8
BIOS SETUP UTILITY
H/W Monitor Boot Security
Configure CPU
Enter Go to Sub Screen
F1
F9
F10
ESC
BIOS SETUP UTILITY
Select the over clock
mode.
[Auto]
[133]
[100]
[Enabled]
[Auto]
Unlocked (Max :17, Min : 14)
17
[17]
[Disabled]
[Disabled]
+- +-
[Enabled]
F1 F1
[Enabled]
F9 F9
[Disabled]
F10 F10
[Enabled]
ESC ESC
[Auto]
Exit
Select Screen
Select Item
General Help
Load Defaults
Save and Exit
Exit
Select Screen Select Screen
Select Item Select Item
Change Option Change Option
General Help General Help
Load Defaults Load Defaults
Save and Exit Save and Exit
Exit Exit