IMPORTANT: This charger comes with a bumper pad installed on the charging well adapter's back rest. This bumper pad helps keep your iPhone or iPod in
place while it's charging. However, some models of iPhone or iPod might not ﬁ t with this bumper pad installed--you might need to replace the bumper pad with
the smaller bumper included, or remove the bumper pad entirely.
Note: If you have the docking well insert that came with your iPhone or iPod, you can use it instead of the well insert that comes with the charger. Just pull the charger's
docking insert out and replace it with the insert made speciﬁ cally for your iPhone or iPod model.
First, test your iPhone or iPod with the bumper pad in place. The iPhone or iPod should slide straight down onto the dock connector easily--DO NOT force it
onto the dock connector. If your iPhone or iPod does not ﬁ t in the well or go easily onto the dock connector, try the other, smaller bumper pad included in this
To change the bumper pad:
Pull the front of the bumper pad gently to remove it from the back rest.
Put the smaller bumper pad on the back rest. Insert the bumper pad's three rubber bumps into the three holes on the back rest and press it to make sure it's
Try docking your iPhone or iPod in the charger with the smaller bumper pad to make sure it ﬁ ts. If your iPhone or iPod still does not ﬁ t in the well or go easily onto
the dock connector, remove the bumper pad and try charging with just the back rest (no bumper pad).
Charger (front view)