Changing The Windscreen Wiper Blades; Changing The Rearscreen Wiper Blades; Spray Nozzles; Headlight Washers Check - Alfa Romeo Brera Owner's Manual

fig. 15
Changing the windscreen
wiper blades fig. 15
How to remove the blade:
– raise the windscreen wiper arm A;
– turn the blade B by 90° around pin
C, on the final section of the arm;
– remove the blade from the pin C.
How to refit the new blade:
– fit pin C into the hole in the middle
of the blade B;
– refit the arm with the blade on the
windscreen.
A0F0080m
fig. 16
Changing the rearscreen
wiper blades
Proceed as follows:
❒ raise cover A-fig. 16 and remove
the arm by loosening the nut B that
secures it to the revolving pin;
❒ fit the new arm, tighten the nut B
and then lower the cover A.

SPRAY NOZZLES

If the jet of fluid is missing, firstly check
that there is fluid in the reservoir: see
"Checking fluid levels" in this section).
Then check that the nozzle holes are not
clogged, if necessary use a needle.
Fluid jets shall be directed at about 1/3
height from the window upper edge.
A0F0249m
HEADLIGHT WASHERS
Regularly check that the spray jets are
intact and clean.
The headlight washers are automatical-
ly switched on when the windscreen
washer is operated and the dipped
beams are on.
229