Features And Functions; Front Panel - Aguilar AG 500SC Owner's Manual

II. Features and Functions
A. Front Panel Features
Input Pad:
-10dB
Preamp Section:
Bright
: +5dB >4kHz shelving
Treble
: +/- 13dB @ 4kHz shelving
High Mid
: +/- 14dB @ 800Hz peaking
Low Mid
: +/- 14dB @ 400Hz peaking
Bass
: +/- 18dB @ 40Hz shelving
Deep
: +6dB <100Hz shelving
Effects Loop Section:
Send
Adjust the level of the
performance from your effects unit.
Return
(This range of signals can be adjusted to get the nominal output
level at the speaker output.) Adjust this knob to optimize the signal
level returning from the Effects Loop. If it is turned up too high,
you can clip the return circuitry of the AG 500. If it is turned down
too low you might not be able to get loud enough.
Pull –20dB
This allows you to use a studio effects unit (line level) or a stomp
box (instrument level) in the Effects Loop. If the signal returning
from the Effects Loop is too quiet, pull this knob to boost the
Return signal.
: Output level = -infinity to +22dBu
Send
: Sensitivity = -20dBu to +infinity
: Boosts the level of the
output to get the maximum
Return
signal by 8dB.
5.