Aguilar AG 500-112C Owner's Manual

Advertisement

Quick Links

Aguilar Amplification's
AG 500-112C
&
AG 500-212C

Owners Manual

August 2005, Manual Version 1.3
1.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AG 500-112C and is the answer not in the manual?

Questions and answers

Summary of Contents for Aguilar AG 500-112C

  • Page 1: Owners Manual

    Aguilar Amplification’s AG 500-112C & AG 500-212C Owners Manual August 2005, Manual Version 1.3...
  • Page 2 The AG 500-212C was designed to give bassists the versatility of the AG 500 bass head with the award winning tone of Aguilar’s GS family of 12” cabinets. Combining portability with versatility, this product was designed to answer the needs of bassists in every genre of music. Another important feature is the inclusion of Aguilar’s first saturation circuit.
  • Page 3 I. Getting Started A. Safety Instructions Please follow these guidelines: A) Vents are provided for heat dissipation at the rear of the amplifier. Maintain at least a 1” space around these vents to provide sufficient ventilation. If you decide to rack mount the amplifier make sure you do not block the vents.
  • Page 4 Channel 2: Master 1. While playing turn up Channel 2’s control until you reach your normal playing level. Because Channel 2 features Aguilar’s saturation circuitry there is no gain control. Saturation 2. Adjust the control to the desired amount of overdrive. The minimum position provides a little tube-like breakup.
  • Page 5 II. Features and Functions A. Front Panel Features Input Pad: -10dB Channel 1 Section Bright : +5dB >4kHz shelving Treble : +/- 13dB @ 4kHz shelving High Mid : +/- 14dB @ 800Hz peaking Low Mid : +/- 14dB @ 400Hz peaking Bass : +/- 18dB @ 40Hz shelving Deep...
  • Page 6 Pull Series : Removes any “dry” (un-effected) signal from the signal path. When this knob is pushed in the Effects Loop is configured in “parallel” and you can mix your “dry” signal with the signal from the Effects Loop. When this knob is pulled out the Effects Loop is configured in “series”...
  • Page 7 C. Footswitch Features Channel 2 : This switch allows you to quickly select your channel. When the LED is lit you are in Channel 2. Operate : This switch allows you to mute the amplifier. When the LED is lit you are in Operate mode, when the LED is unlit the amp is muted. D.

This manual is also suitable for:

Ag 500-212c

Table of Contents