Toshiba BDX3000 Owner's Manual page 37

Downloaded from www.Manualslib.com
Customizing the Function Settings
The symbols that might appear next to each listed wireless
network in the network list are as follows:
Category Icon Defi nition
Connected When the BD player is turned on, it
will connect to the wireless network
displaying this symbol. Typically,
this is the last wireless network
connected before powering down.
Indicates that the BD Player is cur-
*
rently connected to this network.
Saved The wireless network properties
have been saved in the BD player's
memory.
Wireless The wireless network data is not
Security encrypted.
The wireless network data is
encrypted; a 'security key' must be
entered so that the BD player can
share data over the network.
The wireless network data is en-
crypted; the encryption scheme is
not supported by the BD player.
Wireless The wireless network supports
a
Protocol 802.11a
The wireless network supports
b
802.11b
The wireless network supports
g
802.11g
The wireless network supports
n
802.11n
The wireless router supports the
WPS standard.
Signal
Strong Signal
Strength
Good Signal
Medium Signal
Weak Signal
No Signal
I. Connection to the wireless Network which you
select
Wireless
Network List
WiFi Protected Setup (WPS)
Manual
IP Settings
manuals search engine
1. In the "Wireless" menu, press / to select Network
List, then press OK. A list of existing wireless networks
near the BD player will appear (It may take several
seconds for this list to be created). For example:
Network List
WiFi a
WiFi b g n
a
WiFi
WiFi b g
WiFi b g
2. Press / to select the desired wireless network, and
press OK to confi rm.
a. If the BD player is connected to an Unencrypted
Wireless Network, a menu similar to the following will
appear:
WiFi-me
Connect WPS Pin
Name and Password are case-sensitive
3. Press / to highlight Connect, and press OK. If the
wireless network is functioning, icon and a message
"Connection to XXX...Success" will appear on the TV.
4. Press OK to close the message. The BD disc player is
now connected to the network. From now on, when you
turn on the player, it will automatically connect to the
network; there is no need to repeat these steps again.
Note: If you do not see this message, the BD player was
not able to connect to the network.
b. If the BD player is connected to an Encrypted
Wireless Network, a menu similar to the following will
appear:
WiFi-me
Password
Connect WPS Pin Cancel
Press ENTER to open keyboard
Password is case-sensitive
3. Press ENTER to activate the on-screen keyboard.
Carefully enter the network password by using the
/ / to highlight the desired letter on the keyboard,
and then pressing OK. (If you make a mistake, use the
backspace key to erase the mistake.)
WiFi-me*
Panda
dlink_media
NTGR 11g
Airport_SN
Cancel
/
37