Table of Contents
Advertisement
Error Message
DMA Test Failed
Software NMI Failed
Fail-Safe Timer NMI Failed
Device Address Conflict
Allocation Error for device
Failing Bits: nnnn
Fixed Disk n
Invalid System Configuration Data
I/O device IRQ conflict
Operating system not found
System Error – No Beep
Error Message
No beep, power indicator turns off and the
LCD screen is blank.
No beep, power indicator turns on but the
LCD screen is blank.
Chapter 1
FRU/Action in Sequence
DIMM
System board
DIMM
System board
DIMM
System board
Run the Setup Utility, then press F9 to load the system
defaults.
RTC battery
System board
Run the Setup Utility, then press F9 to load the system
defaults.
RTC battery
System board
DIMM
BIOS ROM
System board
None
BIOS ROM
System board
Run the Setup Utility, then press F9 to load the system
defaults.
RTC battery
System board
Run the Setup Utility and see if fixed disk and drive A: are
properly identified.
Diskette drive
Hard disk drive
System board
FRU/Action in Sequence
Power source (battery pack and power adapter). Refer to the
"Power System Check" section on page 65.
Ensure every internal cables are properly and securely
connected.
Reinstall the memory module.
System board.
Power source (battery pack and power adapter). Refer to the
"Power System Check" section on page 65.
Reconnect the LCD-CCD cable.
Hard disk drive
LCD-CCD cable
Inverter board
LCD panel
System board
69
Advertisement
Table of Contents
