Table of Contents
Advertisement
Check the Battery Pack
Check the battery pack via the OS control and by checking the actual battery pack.
Using the OS control:
1.
Open the Power Management setting in the Windows Control Panel screen.
2.
On the Power Meter tab, confirm that the Current Power Source and Total Battery Power Remaining
parameters are correct.
3.
Repeat steps 1 and 2 using both the battery pack and the AC adapter as the power source.
This will help you identify if the problem is on recharging or discharging.
Checking the battery pack voltage:
1.
Power off the computer.
2.
Remove the battery pack and measure the voltage between battery terminals 1 (+) and 6 (ground).
3.
If the voltage is still less than 7.5 Vdc after recharging, replace the battery.
Checking the battery charge function:
1.
Use a discharged battery pack or a battery pack that has less than 50% of the total power remaining when
installed in the computer.
2.
If the battery charge indicator does not light up, remove the battery pack and allow it to return to room
temperature, then reinstall the battery pack.
3.
If the charge indicator still does not light up, replace the battery pack.
Touchpad Check
If the touchpad doesn't work, do the following actions one at a time to correct the problem. Do not replace a
non-defective FRU:
1.
Reconnect the touchpad cable.
2.
Replace the touchpad board.
3.
Replace the system board.
After you use the touchpad, the pointer drifts on the screen for a short time. This self-acting pointer movement
can occur when a slight, steady pressure is applied to the touchpad pointer. This symptom is not a hardware
problem. No service actions are necessary if the pointer movement stops in a short period of time.
66
Chapter 1
Advertisement
Table of Contents
