Panasonic KX-TG7200E Operating Instructions Manual page 38

TG7200-7220E(e).book Page 38 Tuesday, May 22, 2007 9:34 AM
Useful Information
Problem Cause & solution
I cannot make or L The base unit AC adaptor or telephone line cord is
receive calls.
L If you are using a splitter to connect the unit,
L Disconnect the base unit from the telephone line
L The key lock feature is turned on. Turn it off
The unit does not ring. L The ringer volume is turned off. Adjust the ringer
The batteries should L Clean the charge contacts and charge again
be charging but the
battery icon does not
change.
A busy tone is heard L The handset is too far from the base unit. Move
when {C} is pressed.
L Another handset is in use or the answering system
Static is heard, sound L Place the handset and the base unit away from
cuts in and out.
Interference from
L Move closer to the base unit.
other electrical units.
L Your unit is connected to a telephone line with DSL
Noise is heard during L You are using the handset or base unit in an area
a call.
The handset/base unit L Disconnect the base unit AC adaptor and turn off
stops working while
being used.
The handset beeps L Fully charge the batteries (page 12).
intermittently and/or
7 flashes.
I fully charged the L Clean the charge contacts and charge again
batteries, but 7 still
flashes.
L It is time to replace the batteries (page 11).
38
Helpline Tel. No.: U.K. 0844 844 3898 R.O.I. 01289 8333
not connected. Check the connections.
remove the splitter and connect the unit to the wall
socket directly. If the unit operates properly, check
the splitter.
and connect the line to a known working telephone.
If the working telephone operates properly, contact
our service personnel to have the unit repaired. If
the working telephone does not operate properly,
contact your service provider/telephone company.
(page 16).
volume (page 19, 21).
(page 12).
closer and try again.
is being used. Wait and try again later.
other electrical appliances.
service (page 40).
with high electrical interference. Place the handset
and base unit away from interference sources,
such as antennas and mobile phones.
the handset. Connect the base unit AC adaptor,
turn on the handset and try again.
(page 12).