Brother BAS-300G-484/484SF Instruction Manual page 21

<Power supply motor P.C. board>
<PMD P.C. board>
4651M
Connector
Machine head memory 7-pin
Upper shaft motor 3-pin
Synchronizer 14-pin
Connector
Work clamp pulse motor 4-pin black
Thread trimmer solenoid 6-pin
Tension release solenoid 4-pin
Y pulse motor 4-pin blue
X pulse motor 4-pin white
BAS-300G-484, BAS-300G-484 SF
NOTE:
Route the X, Y and work clamp pulse motor
harnesses so that they do not touch the
PMD P.C.
*1:
Be sure to make the ground connection.
(Refer to "3-10. Connecting the ground
wire".)
*2:
Only applicable to -484 SF specifications
Connection location on
power supply motor P.C.
board
P3 (HEAD-M)
P4 (UVW)
P5 (SYNC)
Connection location on
PMD P.C. board
*
2
P3 (PPM)
P6 (SOL1)
P7 (SOL2)
P8 (YPM)
P10 (XPM)
3. INSTALLATION
<Removing>
Press
the tab.
<Securing>
Cord clamp/cable tie
(4)
(5)
(5), (6)
Cable tie
(5), (6)
(5), (6)
(5), (6)
(5), (6)
(5), (6)
(Continued on next page)
.
13