Zanussi ZWH 5105 User Manual page 26

Attention!
Do not place the inlet hose downward.
Angle the hose to the left or right depending
on the position of your water tap.
1. Set the hose correctly by loosening the ring
nut. After positioning the inlet hose, be sure to
tighten the ring nut again to prevent leaks.
The inlet hose must not be lengthened. If it is
too short and you do not wish to move the tap,
you will have to purchase a new, longer hose
specially designed for this type of use.
Water drainage
The end of the drain hose can be positioned in
three ways:
machine is emptying. This could be done by
tying it to the tap with a piece of string or
attaching it to the wall.
26
2. Connect the hose to
a tap with a 3/4"
thread. Always use the
hose supplied with the
appliance.
Hooked over the
edge of a sink using
the plastic hose
guide supplied with
the machine. In this
case, make sure the
end cannot come
unhooked when the
In a sink drain pipe branch. This branch
must be above the trap so that the bend is at
least 60 cm above the ground.
Directly into a drain pipe at a height of not
less than 60 cm and not more than 90 cm.
The end of the drain hose must always be
ventilated, i.e. the inside diameter of the drain
pipe must be larger than the outside diameter
of the drain hose.
The drain hose must not be kinked.
Electrical connection
This machine is designed to operate on a 230-
240 V, single-phase, 50 Hz supply.
Check that your domestic electrical installation
can take the maximum load required (2.2 kW),
also taking into account any other appliances
in use.
Attention!
Connect the machine to an earthed socket.
The manufacturer declines any responsibility
for damage or injury through failure to comply
with the above safety precaution.
Attention!
Should the appliance power supply cable need
to be replaced, this MUST be carried out by
our Service Centre.
Attention!
Please ensure that when the appliance is
installed it is easily accessible for the engineer
in the event of a breakdown.