Zanussi ZWH 5105 User Manual page 16

Select the delayed start by pressing button
7
This option permits to delay the start of the
wash programme by 3, 6, 9 hours.
Press this button repeatedly to select the
required delay. The relevant light illuminates.
You must select this option after you have set
the programme and before you press the
5.
button
Cancelling the delayed start:
You can cancel the delay time at any moment,
before you press the button
If you have already pressed the button
you wish to cancel the delay time, proceed as
follows:
set the washing machine to PAUSE by
●
pressing the button
7
press the button
●
the selected delay goes off.
5
press the button
●
programme.
IMPORTANT!
The selected delay can be modified only
●
after you have turned the programme
selector dial to the «Off» position and after
you have selected the programme again.
The door will be locked throughout the delay
●
time. If you need to open the door, you must
first set the washing machine to PAUSE by
pressing the button
before opening the door. After you have
closed the door, press the button
Note!
The Delay Start cannot be selected with
DRAIN programme.
16
5
.
5
, and
5
;
once, the light relevant to
again to start the
5
and wait few minutes
5
again.
Altering an option or a running programme
It is possible to change any option before the
programme carries it out.
Before you make any change, you must pause
the washing machine by pressing the button
Changing a running programme is possible
only by resetting it. Turn the programme
selector dial to «Off» and then to the new
programme position. Start the new programme
by depressing the button
The washing water in the tub will not empty
out.
Interrupting a programme
5
Press the button to interrupt a programme
which is running, the corresponding light starts
to flash. Press the button again to restart the
programme.
Cancelling a programme
Turn the selector dial to «Off» to cancel a
programme which is running. Now you can
select a new programme.
Opening the door after the programme has
started
First set the machine to pause by pressing the
5
button .
After some minutes, the door can be opened.
If the machine is already heating, that the
water level is above the bottom edge of the
door, the door cannot be opened.
If you cannot open the door but you need to
open it you have to switch the machine off by
turning the selector dial to «Off». After few
minutes the door can be opened
(Pay attention to the water level and
temperature!).
After this procedure, it will be necessary to set
the programme and the options again and then
5
press the button .
5
.
5
again.