Any electrical work required to install this appliance
should be carried out by a qualified electrician or
WARNING: THIS APPLIANCE MUST BE
The manufacturer declines any liability should
this safety measure not be observed.
If the plug that is fitted to your appliance is not
suitable for your socket outlet, it must be cut off and
the appropriate plug fitted.
Remove the fuse from the cut off plug.
The cut off plug should then be disposed of to
prevent the hazard of shocks in case it should be
plugged into a 13amp socket in another part of your
The wires in the mains lead are coloured in
accordance with the following code:
Green and Yellow
If you fit your own plug, the colours of the wires in
the mains lead of your appliance may not correspond
with the markings identifying the terminals in your
plug, proceed as follows:
Connect the Green and Yellow (earth) wire to the
terminal in the plug which is marked with the letter
«E» or the earth symbol
Connect the blue (neutral) wire to the terminal in the
plug which is marked with the letter «N» or coloured
Connect the brown (live) wire to the terminal in the
plug which is marked with the letter «L» or coloured
or coloured green and
The plug moulded onto the lead incorporates a fuse.
For replacement, use a 13amp BSI362 fuse. Only
ASTA or BSI approved fuses should be used.
The plug must not be used if the fuse cover/carrier is
lost. The cover/carrier is indicated by the coloured
insert at the base of the plug.
A replacement cover/carrier must be obtained from
your local Electrolux Service Force Centre.
This appliance complies with the E.E.C. Directive
No. 87/308 of 2.6.87 relative to radio interference
This appliance complies with the following
73/23 EEC of 19.2.73 (Low Voltage Directive)
and subsequent modifications;
89/336 EEC of 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent
Please ensure that when the appliance is
installed it is easily accessible for the engineer in
the event of a breakdown.