Outside Back Exhaust (Horizontal Duct); C1. Adapting Microwave Blower For Outside Back Exhaust - Samsung SMH1622B/XAA Installation Instructions Manual

Step-by-step installation guide
C. OUTSIDE BACK EXHAUST (HORIzONTAL DUCT)
C1. ADAPTING mICROWAVE BLOWER
FOR OUTSIDE BACK EXHAUST
1. Remove and save screw that holds blower Plate
to microwave.
Screw
Blower Motor
3. Carefully pull out the blower unit. The wires will
extend far enough to allow you to adjust the
blower unit.
BEFORE: Fan Blade
Openings Facing Forward
End A
CAUTION: Do not touch blade of blower to prevent
cracking and breaking. Hold outer case when the
blower is removed and re-installed.
4. Rotate blower unit counterclockwise 180 °.
Before Rotation
Back of microwave
SMH8165_XAA DE68-03587A-04-EN_120725.indd 14
2. Lift up the Blower Plate.
Back of
Microwave
Blower Plate Screw
End B
After Rotation
Back of microwave
5. Place the blower unit back into the opening.
AFTER: Fan Blade Openings
Facing Back
End B
CAUTION: Do not pull or stretch the blower unit
wiring. Make sure the wires are not pinched.
NOTE: The blower unit exhaust openings
should match exhaust openings on rear of
microwave oven.
6. Close the blower plate and attach the exhaust
adaptor to the rear of the oven by sliding it
into the guides at the top center of the back
of the oven. Push in securely until it is in the
lower locking tabs. Take care to assure that the
damper hinge is installed so that it is at the top
and that the damper swings freely.
Adaptor
Guide
From Blower motor screw
(after attached the exhaust adaptor)
14
End A
Back of
Microwave
Guide
blower plate screw
2012-07-25 8:05:31
3.
IN
A
B
C
D
E.
A
Yo
ou
•
•
•
C
ca